I too had a choppy sound problem until I swapped the E-UAE executable to the SDL version of E-UAE instead of the AmiGFX version which is installed by default in OS4.1. it works a lot better
make sure you disable the JIT as a default...... and only enable it where required for certain games..... Alien Breed 3d AGA for example works better when the JIT is enabled but for a lot of the older games switch it off
Last edited by outrun1978 on 20-Nov-2016 at 08:47 PM. Last edited by outrun1978 on 20-Nov-2016 at 08:46 PM. Last edited by outrun1978 on 20-Nov-2016 at 08:44 PM.
Joined: 6-May-2007 Posts: 11180
From: Greensborough, Australia
@outrun1978
One of the graphics.library updates before FE came out also rejects it even if the hardware supports it. You have to set it up as double scan. Example from my monitor tooltypes:
MODE=320x256@60D
Status: Offline
fishy_fis
Re: Improving E-UAE performance on AmigaONE 500 / Sam460 Posted on 24-Nov-2016 6:05:57
Should I be outputting via VGA as am set up via a HDMI cable and in the 320*256 doublescan resolution I get a black screen when trying to run a game in E-UAE....
Joined: 6-May-2007 Posts: 11180
From: Greensborough, Australia
@outrun1978
You may need too. I don't know if HDMI goes down that low. Can't find any inf on minimum resolution. You may need to use 640x480 as a baseline. Yes that would be slower for low res I'd say.