So I have reconnected my Amiga after getting it re-capped. And I am trying to install a new CF card hard drive. I have done it before more that once, I have no interest in using a PC since I don't own one and UAE to do it. I have always done it on my amiga. I have a brand new connector and a brand new Kingston CF card, but my system won't recognize it. When I have the jumper set one way the connector light and my H Disk light on the Amiga are always on. So it is getting power. Change the jumper and no light at all. So any and all advise that any of you could give me would be much appreciated. Thank you Brad Hansen
Status: Offline
g01df1sh
Re: Questions for setup of CF card for IDE connection Posted on 22-Sep-2018 21:29:05
Normally your 'CF Card connector' should be a IDE to CF-Card Interface. So if you have connected it right and used the power connectors provides with it, you must still format your CF card with HD-Toolbox.
Try first with the 2GB card, one partition with maximum size and default parameters should work.
Last edited by OneTimer1 on 23-Sep-2018 at 07:17 PM.
Status: Offline
g01df1sh
Re: Questions for setup of CF card for IDE connection Posted on 23-Sep-2018 20:33:18