Software News : HyperClock - A utility to temporary modify CPU and FSB clock settings for Sam440
posted by afxgroup on 3-Aug-2011 13:04:52 (2275 reads)
HyperClock
A utility to temporary modify CPU and FSB clock settings for Sam440ep boards (all versions)
Author:
Max m3x Tretene, Soft3
What it does:
* it allows to temporary modify CPU and FSB clock settings. The new configuration to become active requires a soft reboot, and will be active until the next hardware reset (from the computer case button) or until the board is switched off. After that the board will boot again with the original clock settings. This way it's possible to safely reboot the board in case a wrong clock setting was chosen. * it's possible to over clock and under clock the board. Under clocking may be useful in case you need to run the board for a long time on a specific task which requires low CPU power, for example, allowing to save on electric energy consumption, and lowering the heat produced. * it reports some useful information on the board, and may help to solve some misconfiguration problems
BIG FAT NOTE:
* There is the remote possibility that something may go wrong damaging your hardware. Use this tool with extreme caution and at your sole risk. Please beware that every damage to the board due to incorrect settings or misuse of this tool will not be covered by the board warranty.
Nice APP, but when use clock from 733 to 800 mhz and 166 mhz fsb....Glquake locks up...
:) Sam440 flex 733 ati9250 radeon...
That simply means your board can't go that fast. Try lowering one or more of the settings. Lockups due to overclocking typically shows best under stress, like 3D gaming or when pushing the altivec unit (for those who have one).
Status: Offline
Amigo1
Re: HyperClock - A utility to temporary modify CPU and FSB c Posted on 5-Aug-2011 13:55:32
56 guest(s) on-line.
2 member(s) on-line.
TheDaddy 
