cool! could it be possible that pcmcia would support this via squirrel scsi cable?

_________________
nox's in the house!

already bought one off Ebay last week but would have much preferred to buy it form you guys

_________________
____________________________
c64-2sids, A1000, A1200T-060@50(finally working!),A4000-CSMKIII
! My Master Miggies- Amiga 1000 & AmigaOne X1000 !
mancave-ramblings
X1000 I BELIEVE

Nice! I think I can use a couple of those.

Now to find a reasonable SCSI to SATA adapter. The ones out there are very out there $$$

Chris

Is this will work on this same cable BPPC-SCSI+cable50pin ?

_________________
A1200 BlizzardPPC BVision FastATA Eth 3Com, EFIKA5K2

Yes it would. Thanks.

_________________
Amiga Kit Amiga Store
Links: www.amigakit.com | New Products | A600GS

What are the transfer speeds during read and write?

_________________
A1SE: G3@600MHz, 2GB, 1GBit network card
A1XE: G4@933MHz, 2GB, refitted AC'97 codec
microA1: G3@800MHz, 1GB

- A1 Linux support -

@Geri:
Since the board looks to be originating from this project:

http://www.codesrc.com/mediawiki/index.php?title=SCSI2SD

I guess the numbers on that page are still valid. Which means it's not really suited for high performance SCSI hardware, but would probably be very nice for your A590 or older A2000 SCSI cards, or even A3000 mainboard one.

The same wiki page also lists additional board versions (2,5") and other sources to purchase.

_________________
MorphOS, classic Amiga, demoscene, and stuff
"When a bridge is not enough, build a Viaduct!"
"Strip the Amiga community of speculation and we can fit every forum on a 720k floppy" (by resle)

I installed one of these in my GVP 530 a couple weeks ago and I couldn't be happier. Most apps start instantly and I think it's a bit faster than the old SCSI 1 drive that it replaced.

Also heat is drastically reduced and it's totally silent.

_________________
Micro A1 866 Mhz and AmigaOS 4.1
PowerMac G4 1.4 Ghz and MorphOS 2.7

A PATA version would be good, to replace all those aging, heat-producing, noisy IDE drives out there.

_________________
cheers
tony

Hyperion Support Forum: http://forum.hyperion-entertainment.biz/index.php

PATA version? You can get a variety of PATA to SD adapters on eBay for peanuts. Both 40pin and 44pin versions exist. Most of them work fine with Amiga computers. (It seems AmigaKit only has IDE to CF in stock, maybe they will add an IDE to SD later?)

_________________
MorphOS, classic Amiga, demoscene, and stuff
"When a bridge is not enough, build a Viaduct!"
"Strip the Amiga community of speculation and we can fit every forum on a 720k floppy" (by resle)

Not sure if it will make a difference but there are different class types of micro SD cards. So a faster card may improve speed.

it should now be possible to transfer data direct from your smartphone to computer (if phone has SD card slot). ..photos,videos & files.

_________________
The Machine: Bride Of The Pin•Bot by Williams Electronics

how would you mount it in a A2000?

well opened up my A1000 scsi drive case to install one of these BUT this is what I found:

a 3.5" MFM 30MB HD. So it looks like the scsi controller is going thorugh a ST506 interface then to the MFM HD so question is there an adapter to go back to scsi?? or can I get an adapter from the scsi controller direct to the scs2sd board??
some info on my HD (Golem HD3000A) here

so anyway to use this or, if not, does anyone want to buy one new never opened

Last edited by klx300r on 31-Oct-2015 at 08:31 PM.

_________________
____________________________
c64-2sids, A1000, A1200T-060@50(finally working!),A4000-CSMKIII
! My Master Miggies- Amiga 1000 & AmigaOne X1000 !
mancave-ramblings
X1000 I BELIEVE