I think copy+paste+merge from Peg1 and Marvell-ref-board would give a realistic picture .....
What about a straight ?copy and paste? from Momentum's PPC 970 eval board?
Note that Genesi has build AGP bridging circuits, thus it's not a straight "copy & paste" engineering job.
I defined ?copy & paste? engineering job in the level of Leadtek?s nForce2 motherboard vs NV's reference motherboard i.e. NV has stated that they are the ?closest?.
Joined: 3-Feb-2004 Posts: 584
From: Lincoln, England
@Kronos
This is just a guess but I suspect the Via southridge and acompnging wiring was brought over from the Peg 1 along with the CPU card edge connector pinout (but no or very little wiring) and the rest was taken from marvells reference docs apart from the AGP slot which is a FPGA which interfaces between the PCI-X and AGP slots doing the nessacery conversions
43 crawler(s) on-line.
64 guest(s) on-line.
1 member(s) on-line.
Hammer 
