Hi All,

So I have reconnected my Amiga after getting it re-capped. And I am trying
to install a new CF card hard drive. I have done it before more that once, I
have no interest in using a PC since I don't own one and UAE to do it. I have always
done it on my amiga. I have a brand new connector and a brand new Kingston
CF card, but my system won't recognize it. When I have the jumper set one way
the connector light and my H Disk light on the Amiga are always on. So it is getting
power. Change the jumper and no light at all. So any and all advise that any
of you could give me would be much appreciated.
Thank you
Brad Hansen

@Punkyclown

What size is the cf

_________________
A1200 ACA1232 128MB Indivison MkIICr
Elbox empty Power Tower
RPi3 Emulating C64 ZX Atari PS BBC
Wii with Amiga emulation
Vampire v4 SA

@Punkyclown
Connector inserted backhand must respect pin 1
Careful risk of burning the CIA chip

Last edited by cip060 on 22-Sep-2018 at 11:24 PM.

@cip060

Thanks for responding, System is working just fine... I have two 4gigs and
one 2gig to use, none are showing up...

Brad Hansen

@Punkyclown

Normally your 'CF Card connector' should be a IDE to CF-Card Interface. So if you have connected it right and used the power connectors provides with it, you must still format your CF card with HD-Toolbox.

Try first with the 2GB card, one partition with maximum size and default parameters should work.

Last edited by OneTimer1 on 23-Sep-2018 at 08:17 PM.

@OneTimer1

Have you tried your cards in a PCMCIA adapter?

_________________
A1200 ACA1232 128MB Indivison MkIICr
Elbox empty Power Tower
RPi3 Emulating C64 ZX Atari PS BBC
Wii with Amiga emulation
Vampire v4 SA

@g01df1sh

Might be worth trying a standard 2.5" hard drive if that is not seen then. I would say your motherboard has a fault. Has it been recapped ?

_________________
A1200 ACA1232 128MB Indivison MkIICr
Elbox empty Power Tower
RPi3 Emulating C64 ZX Atari PS BBC
Wii with Amiga emulation
Vampire v4 SA